Air Weigh BinMaxx, Руководство по установке

Страница: 17 / 28

14
Installing the Display
1. Select a location on the vehicle dash where the display will
be easy for the driver to see and where the buttons are easy
to access from the driver’s seat.
2. Verify that the display cable is long enough to reach from the
ComLink to the display before installing the cable.
3. If necessary, drill a 1/2-inch hole in the dash to run the
display cables from the ComLink to the display. If there is
an existing access hole for other dash-mounted devices
available, use it if possible.
4. Clean the dash surface using one of the alcohol pads.
5. If you have a mounting pod skip to step 7. Connect the
display cable to the ComLink, then run the cable to the
display and connect it.
6. Remove the adhesive tape backing and adhere the display
using 15 lbs of pressure for 60-seconds.
7. Mount the pod’s base using the double-sided tape or screw it
directly to the dash. Use the provided drill template if you are
using screws.
8. Connect the display cable to the display and press the cable
into the routing groove.
9. Adjust the display until it sits at the desired angle.
10. Tighten the handle to secure the display to the swivel mount.
Setting the A/D Values
At this point, you have installed all of the BinMaxx system
components. You will next adjust the deflection sensors to read
weight correctly by setting their A/D values. Please note that “A/D”
refers to the analog-to-digital conversion of the sensor reading.
When setting the A/D values, the fork tubes need to be close to the
ground, without touching the ground. The forks should be pointing
upwards, towards the sky.