Air Weigh BinMaxx, Руководство по установке

Страница: 15 / 28

12
Installing the ComLink Wiring Harness
The 10-pin ComLink interface wiring harness connects the BinMaxx
system to the vehicle’s electrical system and the display. See image
on next page for a map of the wiring harness and placement of
connectors in the ComLink.
Follow these steps to install the ComLink interface wiring
harness:
1. Connect the white wire to chassis ground, and connect the
blue wire to key hot power source (Do not connect directly to
ignition switch).
2. Connect the 4-pin connector on the cable labeled “High-Prox
Connector” into the corresponding port on the ComLink. The
other end of the cable will be attached to the high-prox cable
that comes from the proximity sensor.
3. Connect the 4-pin connector on the cable labeled “Low-Prox
Connector into the corresponding port on the ComLink. The
other end of the cable will be attached to the low-prox cable
that comes from the proximity sensor.
4. Connect the 10-pin connector to power port on the ComLink
(reads “Power/Ground/Aux Out/Display”).
5. Secure the wiring using zip ties as needed.