Air-Vac PCBRM15, Руководство пользователя

Страница: 90 / 120

Pcbrm15 & PCBRM System 5.2 User’s Manual Chapter 6: Troubleshooting
Part No. 4005.00.906
6-4
6.1.3 Poor Solder Results
1. Un-level pump (see leveling procedure).
2. Un-level machine (see leveling procedure).
3. Z-Axis height not set correctly.
4. Baffle not being used.
5. Flow duration not set correctly.
6. Ramp up/down not set correctly.
7. Consult Air-Vac for further help.
6.1.4 Excessive Fluctuation of Solder Wave
1. Replace motor belt.
2. Motor belt tension too tight.
3. Solder pump needs to be removed from pot, disassembled and thoroughly cleaned.
4. Consult Air-Vac for further help.
6.1.5 Fault Indication (CAL9900 only)
Temperature display, on a fault indication, is replaced by “EE” flashing, followed by a digit. This indicates
that an error has been detected in the system. Action should be taken as follows:
EE1 – S
ENSOR
B
URNOUT
– C
HECK SENSOR AND
/
OR CONNECTIONS THEN KEY
*
EE2 – T
EMPORARY
S
YSTEM
E
RROR
S
ELF
C
LEANING
EE8 – L
OSS OF
C
ALIBRATION
EE9 – NVM D
ATA
F
AULT
(
NON VOLATILE MEMORY
)
Note: Repair & Re-Calibration
D
UE TO THE NATURE OF ITS DESIGN
,
THE
9900
CAN ONLY BE REPAIRED AND RE
-
CALIBRATED
BY USING SPECIAL EQUIPMENT AND SHOULD BE RETURNED TO
A
IR
-V
AC IF FOUND TO BE
FAULTY
.
Note
T
O RESET
EE9
FAULT
(
CAUSED BY SPIKING
),
TURN OFF MACHINE
,
PRESS
“P”
IN AND TURN ON
POWER UNTIL DISPLAY COMES ON LINE
. P
ARAMETER LOCK NEEDS TO BE IN THE SETTING
POSITION
.