Air-Vac PCBRM15, Руководство пользователя

Страница: 48 / 120

PCBRM15 & PCBRM System 5.2 User’s Manual Chapter 4: Processes & Applications
Part No. 4005.00.906
4-6
Flow Well
Carrier Arms
Z-Height Adjustment Wheel
Flow Well
parallel
PCB
Solder Flow Rate Control
Carrier Arm
(A)
(A)
•
• Using the Z-Axis Height Adjustment Wheel, lower carrier to allow Carrier Arms to touch side of Flow
Well.
•
Adjust Flow Well parallel to carrier arms or use edge of a pcb as a guide to square the flow well as
shown in photo.
Adjusting PCB Height:
• A space of approximately 1/16” between the top of the flow well and the bottom of the pcb. Molten
solder needs to flow through this space, contact all leads and flow freely back into the solder pot.
Use Z-height adjustment wheel to adjust.
• PCBRM System 5.2 – Once height is set, loosen and then lock the z-height adjust (A). Once set,
unit is set for repetative processes.
C
AUTION
:
I
NSUFFICIENT CLEARANCE COULD FORCE THE SOLDER TO FLOW UP THROUGH THE BARRELS
OF THE BOARD AND FLOOD THE TOP OF THE BOARD
. I
T COULD ALSO CREATE A SAFETY
CONCERN FOCING SOLDER UNDER PRESSURE OUT OF NARROW FLOW WELL
/
PCB
OPENINGS
.S
OLDER CAN DEFLECT ALONG THE BOTTOM OF THE PCB TO ADJACENT AREAS
.
Bottom of
PCB
Top of
Flow Well
1/16”