Air Techniques Hydromiser H-2, Инструкции по установке и обслуживанию

Страница: 3 / 4

Page 3
Air Techniques, Inc.
Installation Procedure
1. Preparing VacStar
A. Cut 3/8” Poly·Fio tubing (A), midway between
(B) and (C)
B. Install supplied union connectors on the cut
end of each tubing section.
• The 1/4” X 3/8” reducing union is
installed to the upper (B to A) tubing
section.
• The 3/8” X 3/8” union is installed to the
lower (C to A) tubing section.
NOTE:
Figure 1 shows VACSTAR 20.
VACSTAR 40 is similar except main power connection is
made via provided hospital grade NEMA 6-15P line cord.
Figure 1. VacStar 20 and 40 Preparation
V
AC
S
TAR
®
B
A
C
Push To Connect
Water Inlet
Connector
As shown by Figure 2, install the sup-
plied pressure regulator on the water
supply line.
3. Connections between the VacStar and HydroMiser
Connect the 1/4” tubing, the 3/8” tubing and the 3/4” hose between HydroMiser and the VacStar as
shown by Figure 3.
Figure 2. Pressure Regulator Installation
Pressure
Gauge
¼
inch tube
to Water Inlet
Connector
Pressure
Regulator
Water Inlet
Strainer
½
inch FNPT
Shut-Off
Valve
2. Water Pressure Regulator Installation
Figure 3. HydroMiser Installation
V
AC
S
TAR
®
3/8” tubing with 3/8” X 1/4”
reducing union that accepts
1/4” Hydromiser connection.
A
B
3/4” drain hose connection to
top of Hydromiser.
See Figure 4 for Hydromiser
drain connection options.
C
B
A
1/4”
3/8”
3/8” tubing with 3/8” X 3/8”
union connector that accepts
3/8” Hydromiser connection.
C
3/4”