1. Make sure the air cleaner is securely
fastened to the true ceiling.
2. Replace the power module (X-11Q only) and
reconnect the electronic plugs.
3. Check to make sure the electronic cells are
oriented for correct airflow--arrows on side
of cell should point up. The contact board
on the cell should align with the contact
board on the power module.
4. Make sure the intake grille opens easily and
the electronic cells and the prefilter are
secure in the unit.
5. Turn the electrical power back on.
6. Make sure the fan runs on all three-speed
settings. The system light should be on
when the fan is running.
7. Press the test button. An audible snap
indicates the collection section of the cell is
functioning.
8. Opening the intake grille stops the fan and
turns out the system light.
9. Clean up surfaces of the air cleaner and the
installation area.
NOTE: If the air cleaner does not appear to work right, refer to the Electrical Troubleshooting section.
SAFETY INTERLOCK SYSTEM -
In order for all
air cleaner functions to receive operating power,
the grille must be securely in position. This
actuates the safety interlock switch. The air
cleaner will not function without the grille in place.
FAN SWITCH
- Your electronic air cleaner has an
Off-Low-Med-Hi switch. The electronic
collection system and built-in fan are designed to
run simultaneously. Turn off the air cleaner
before opening the access door to remove the
electronic cells for cleaning.
SYSTEM LIGHT
- Your electronic air cleaner is
equipped to tell you simply and quickly that it is
working properly. The amber system light tells
you at a glance the status of the power supply.
The system light should be on when the unit is on.
TEST BUTTON
- Pushing the white button labeled
“push to test” generates a snapping noise that
indicates proper function of the collector cells.
OPERATING INSTRUCTIONS
CHECKOUT
Page 9
S M O K E M A S T E R C - 1 2 O W N E R ' S M A N U A L
Pure n Natural Systems, Inc. | purennatural.com | 1-800-237-9199