Feniks FUTURE Instruction Manual, No.
033-02-200
edition
IA
, 2012, page
15
of
36
AIR-POL Sp. z o.o.
– 05-120 Legionowo, ul. Olszankowa 52, www.air-pol.com.pl
tel.: (+4822) 774 0711, (+4822) 784 1595, (+4822) 774 4832, fax (+4822) 784 9640, @: [email protected]
Photo No. 24
5.
Follow the owner’s manual of the given
canopy when folding the canopy, the leading
edge, and the trailing edge, and determining
the position of the slider.
6.
The Feniks container requires that the reserve
parachute canopy be
U
-shape packed,
allowing the closing loop to be threaded
through the inside of the free-bag.
The folded canopy should be approximately
5 cm wider than the free-bag. This allows for
the free-bag and the reserve parachute
container to be well filled.
ATTENTION!
In the photograph, the canopy is blocked with
a tape (5) which must be removed after
closing the free-bag.
Photo No. 25
7.
Thread the temporary closing line (6) through
the eyes in the upper and lower free-bag
surfaces.
8.
Place the prepared canopy inside the free-bag
filling it snugly, and form it to fit the shape of
the reserve parachute container.
9.
Thread the canopy suspension lines between
the eyes (7)
10.
Close the free-bag with the closing flap by
threading appropriate ends of the rubber loop
through the flap’s grommets, and block it with
line weaves.
External weaves shall be no less than 5 cm in
length.
ATTENTION!
If using a buckled tape (5) to keep the folded canopy in place – make sure it was removed! (Photo No. 24.).
Photo No. 26
11.
Place suspension lines in the pouch in the
bottom of the free-bag as shown in the
photograph.
Before placing lines in the pouch, secure the
hooked side of the Velcro tape with a
temporary Velcro tape section.
12.
Leave approximately 30 cm of suspension
lines unwoven.
13.
Remove temporary Velcro tape sections and
close the line pouch.
Make sure that canopy suspension lines are
not trapped between Velcro tape sections.
7
6
5
