Air Lift Load Controller II 25812, Руководство по установке

Страница: 7 / 12

5 MN-337
STEP BY STEP INSTALLATION
All of the electrical connections are matched by male-to-female push-in terminals. All of the
air line connections will be white- to-white, no tape-to-no tape, indicated by the color band.
The color band also serves as a reference point for installing the air line into the fitting.
Properly installed, the front edge of the color band should be against the collar of the fitting
(fig. 4 and 5).
1. Install the gauge panel. Select a convenient mounting location that has a sturdy rigid
surface. The bottom edge of the dash on either side of the steering wheel is a good
location. Attach the panel to the selected location with the black self-tapping screws.
2. Install the compressor unit.
a. Hold the compressor in the recommended location (fig. 6) and use the provided silver
self tapping screws to attach the mounting brackets to the vehicle.
b. In some cases the mounting area does not provide enough room to use a drill to
drive the screws in. It may be necessary to use the mounting brackets as a template
to drill 13/64” holes through the frame first and then use a 7/16” nut driver to install
the self tapping screws.
Attach the ground wire to one of the screws (fig. 1).
c. For box frames: In some cases the frame section will not be wide enough to mount
the compressor legs flat to the rail. Refer to fig. 6 in this situation.
DO NOT DRILL ANY HOLES INTO THE FRAME OR THE FLOOR BOARD BEFORE
CHECKING FOR HYDRAULIC LINES, GAS LINES, AND/OR ELECTRICAL WIRES
THAT MAY NEED TO BE MOVED ASIDE. ALSO, WHEN ATTACHING TO THE FLOOR
BOARD, IT IS IMPORTANT TO CHECK WHERE THE SCREWS PROTRUDE THROUGH
THE FLOOR BOARD. IT MAY BE NECESSARY TO TRIM OR COVER THE TOP OF THE
SCREWS INSIDE THE VEHICLE. A SEALER SHOULD BE USED AROUND THE SCREW
fig. 5
No tape air line
to no tape tee
Harness #2 Harness #1
White
banded air
line to white
banded tee
Compressor side
Gauge side
Power (red) wires
fig. 4
No tape tee
White
banded tee
White banded
air line
No tape
air line
Harness #1
NOTE
CAUTION
Load Controller II