7
MN-754
Air Lift Performance
Air Lift Performance
1
2
3
4
5
6
7
8
RR
LR
RF
LF
T
Button Definition
fig. 2
SYSTEM CALIBRATION AND
SETTINGS
1.
Key-on/power up, and compressor should
come on to fill the tank. Check to make
sure system is triggered by IGNITION
source. While starting the engine, the
system should be ON. If not, please refer
back to the “Install Harness” section.
2. Press buttons 1 and 5 simultaneously
(1+5) and hold for 5-10 seconds until
settings and diagnostics mode main page
appears (fig. 3).
Tank Adjust (Maximum System PSI)
Press button 1 (TANK ADJUST). Set tank
pressure preference by pressing MAX up/
down buttons simultaneously (fig. 4). The MAX
value sets compressor cut-off pressure. Press
buttons (1+5) simultaneously to exit to settings
and diagnostics mode.
MIN tank pressure will follow MAX within 15
PSI to provide further accuracy.
If tank MAX settings are changed, a system
recalibration is necessary for optimal
performance. Max tank pressures for various
compressors can be found in table 2.
Calibrate to your vehicle
Press button 2 to enter CALIBRATE (fig. 3).
Press button 1 SYSTEM CAL (fig. 5), follow
instructions to calibrate AutoPilot V2 system
to your vehicle. Once calibration is complete,
Press buttons (1+5) simultaneously to exit to
settings and diagnostics mode.
TANK MAX=175
fig. 4
1. TANK ADJUST
2. CALIBRATE
3. BACKLIGHT
4. PRESET MAIN
fig. 3
CALIBRATION MENU
1. SYSTEM CAL
2. ADJUST SYSTEM
fig. 5
DURING CALIBRATION THE SYSTEM WILL AUTOMATICALLY DEFLATE TO 0 PSI AND
RAISE TO 100 PSI ON EACH AXLE AUTOMATICALLY. IF WHEELS EXTEND BEYOND
FENDERS, VEHICLE DAMAGE MAY RESULT. CALIBRATION ON NARROW WHEELS
THAT TUCK INSIDE THE FENDERS IS RECOMMENDED. ALSO, MAKE SURE VEHICLE
BODYWORK WILL NOT BE HARMED IF ONE END IS RAISED TO 100 PSI AND THE
OTHER IS AT ZERO. IF DAMAGE IS POSSIBLE, IT MAY BE BEST TO CALIBRATE BY
SETTING VEHICLE ON BLOCKS OF WOOD (SAME HEIGHT) TO GIVE THE BODYWORK
MORE CLEARANCE.
CAUTION
Backlight Setting
Press button 3 to enter BACKLIGHT (fig.
3). Set display backlight to your preference
by pressing the + and – on R (Red), G
(Green), B (Blue) (fig. 6). Press buttons
(1+5) simultaneously to exit to settings and
diagnostics mode.
+ + +
BACKLIGHT
R G B
- - -
fig. 6
NOTE
