MN-754
Air Lift Performance
Air Lift Performance
Program Presets
Program Preset 1
Preset 1 should always be entered as the desired
ride pressure for the RISE ON START function.
Determine desired ride pressures: press
buttons (1+5) simultaneously to toggle display
to MANUAL mode. Manually activate each
corner (see MANUAL mode section page
13) to achieve desired “normal driving” ride
pressure (fig. 11). Program preset 1: press
buttons (1+5) simultaneously to toggle display
to PRESET mode (fig. 12). Press and hold
button 1 for 3 seconds to set preset 1. Release
button and actual air spring pressures will
appear (fig. 12). Fine-tune the pressures by
pressing up/down buttons. Press and hold to
scroll. Press buttons (1+5) simultaneously to
save and exit.
Program Presets 2-8
You are now free to program the additional 7
presets to desired pressures. Typical presets
can be:
•
“Low”: set pressures to the lowest
possible pressures for extreme low
driving stance.
•
“Front up”: for speed bump or driveway
clearance.
•
“Rear up”: for added load of
passengers, equipment.
•
“Play”: for those that want to enjoy their
air suspension freedom, AutoPilot V2
has a special function that recognizes
side-to-side presets. When left side
pressures are equal, and right side
pressures are equal but >25PSI
different than left, the algorithm will
activate side to side instead of front
to back. It will also equalize all air
spring pressures when exiting the
“play” preset, conserving air by using
the high pressure side to inflate the
low pressure side. Pairing two “play”
presets together allows side-to-side
activation that consumes far less air
than manual mode activation would
consume.
NOTE
64 66 82 80
150
fig. 11
65 65 80 80
PRESET 1
EDIT
fig. 12
5 100 5 100
EDIT
PRESET 6
fig. 13
1
2
3
4
5
6
7
8
RR
LR
RF
LF
T
Button Definition
100 5 100 5
EDIT
PRESET 7
fig. 14
fig. 2
Sample Pressure Layouts
for Play Mode (figs. 13 & 14)
