Air innovations WINE GUARDIAN DS025, Инструкция по установке, эксплуатации и обслуживанию, Страница: 23 / 61

23
Wall Mounting - If the Evaporator is to be surface mounted on the wall, adequately
support it on both sides of the wall. Use floor or knee braces to transfer the load of the
unit to the floor or wall.
Ceiling Mounting - Construct a structurally sound, level platform to place the
Evaporator on when hanging it from the ceiling joists. The Wine Guardian fan coil is
NOT designed to be suspended from the top of the unit; it must be supported from the
bottom. Place the unit on a platform to ensure the unit is supported on all four corners.
Leave adequate space above the unit to remove the access doors for service.
In all cases the unit must be level to within ±0.25
” (±6.35mm) end-to-end and ±1/8”
(±3.18mm) side-to-side for proper operation. Locate the unit as close to the wine cellar
as possible to reduce the length of the duct runs. If possible, use straight ducting on
all duct work.
Reducing Noise Generation
Consider noise when locating the unit close to the cellar or to an adjacent occupied
space. The addition of 0.25
” (6.35mm) thick rubber pads under the unit will help
prevent the transmission of vibration and noise. A piece of 1
” or 2” (25 or 50mm) noise
dampener between the unit and the wall absorbs and reduces noise from the unit. For
air noise, use flexible ductwork to absorb the noise. Sound usually travels as a line of
sight. Sound is reduced when it turns a corner, such as passing through a bend in
ductwork. If the unit is supported from a wall or joist, using a rubber pad under the unit
will reduce noise caused by vibration.
Ductwork
Wine Guardian units are typically installed indoors near the wine cellar to minimize duct
runs. Each unit is provided with one entering (or return) air inlet and five possible supply
air outlets for the evaporator sections. A maximum cumulative total length for both
supply and return ducts (including bends) of 25 ft (7.5 meter) is recommended. If longer
runs are needed, examine your duct runs using our
Ductwork Calculator .