To prevent spilling oil where it could cause damage to nature,it is strongly recommended
that you use an oil changer to change the engine oil.If an oil changer is not available,drain
the engine oil by removing the drain screw.If you are not familiar with the procedure for
changing the engine oil,consult your dealer.
1.Put the outboard motor in an upright position (not tilted).
NOTICE: If the outboard motor
is not level,the oil level indicated on the oil dipstick may not be accurate.
2. Start the engine.Warm it up and keep the idle speed for 5-10 minutes.
3. Stop the engine and leave if for 5-10 minutes.
4. Remove the top cowling.
5. Remove the oil filler cap.
1. Oil filler cap
2. Oil lubrication check window
TIP:
The oil lubrication check window does not indicate the engine oil level.Use the oil
lubrication check window to make sure that the engine is being lubricated with oil while it is
running.
6. Insert the tube of the oil changer into the oil filler hole,and then extract the engine oil
completely using the oil changer.
1.Oil changer
