9
PART NAMES
INSTALLATION
USING THE SYSTEM
APPENDIX
SETTING AND ADJUSTMENT
Mounting procedure
<Back wiring>
Mounting bracket
(pre-attached by factory)
3-gang box
The unit
Mounting screw × 4 (not included)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
CAT5e
cable
83.5mm (3-5/16")
Connect the CAT5e cables to the unit.
2
Opening/closing the terminal cover
To open:
Slide the cover to the right until it clicks, and then open.
To close:
Close the cover, and then slide it to the left until it
clicks.
Make sure the cover is locked.
*
<Surface wiring>
When the wiring is not coming through the wall, the cable and wires can be routed through the top or bottom of the cable inlet.
Remove cable inlet plate on the upper part of the unit to allow passage of the wiring into the unit.
Cable inlet plate
Mounting bracket
(pre-attached by factory)
The unit
Wood mounting screw × 4 (not included)
Screw shaft: Ø4.1 or less
Slotted head: Ø8.2 or less, 3.0mm or less in height
CAT5e cable
83.5mm (3-5/16")
92mm (3-5/8")
Fasten the mounting
1
bracket to the wall.
Mount the unit on the
3
mounting bracket.
Terminal cover
Close
Open
