PB-1000 PANEL BEATER
TM
PRODUCT MANUAL
PAGE 13
PULLING A
DENT
1. SAND:
Sand paint from dent area.
3. ATTACH ELECTRODE:
Screw an electrode PB-104 into the electrode holder.
• Set
timer
to desired setting or metal thickness.
• It is recommended to start at a low setting (e.g. “0”) and in-
crease as needed.
4. STICK:
• Firmly push the electrode tip against the spot to be pulled and
push the thumb switch (on the electrode handle) until it sticks.
• Release after 1-2 seconds.
5. PULL:
• Pull straight out firmly on the handle being careful not to twist
or tilt.
• It may be useful to use a body hammer to work the metal.
6. TWIST:
• To release the electrode, give the handle a clockwise twist.
2. GROUND:
Place magnet (ground) on sanded area near dent to be repaired.
DENT PULLING
REPEAT AS NECESSARY.
