9
Figure 3 Wall or Ceiling Mount
Figure 4 VariFocal Series Adjustment Points
Figure 5 Fixed Focal Series Adjustment Points
5. CAMERA ADJUSTMENT
5.1 MLAR VariFocal Series
Ceiling Mount
Remove two screws and discard plate
when mounting to a two gang
electrical box.
2.
Insert screws through
the holes and attach
to the mounting box.
Sample Anchor Type
Cable, Conduit Opening
(Sample Ceiling Tile - not included)
3. Secure the unit to the wall or ceiling.
4. After making camera adjustments,
replace the dome cover to the unit.
1. When mounting the unit to the wall, position the
unit such that the cable knockout is toward the floor.
See
Detail A
Tilt adjustment;
Thumb Nut.
Note: the entire bracket
rotates.
rotate adjustment dial.
adjustments have been made.
6. When camera position is set,
replace dome cover.
1. Remove Dome Cover.
3. Adjust for proper tilt
orientation by using the Thumb nut.
2. Adjust the camera for vertical and
horizontal tilt using the Thumb Nut.
4. Rotate the bracket for proper
pan adjustment.
5. To square camera once
Tilt adjustment;
Thumb Nut.
Phase Adjust
5.2 MLAR Fixed Focal Series
Adjustment Dial
Pivot Point A
Thumbnut
Pivot Point A
Thumbnut
Pivot Point B
1. Remove Dome Cover
3. Adjust the base for proper Pan
at Pivot Point B by rotating the
entire base bracket.
2. Adjust the camera for horizontal tilt
by using the thumbnuts at Pivot
Points A.
4. Re-Tighten the thumbnuts as
needed.
5. To Square the camera once
all adjustments are made
rotate the adjustment dial.
