Fixing and Maintenance Instructions
Ver. 5 4/2014 (1003)
2
INTRODUCTION
Thank you for deciding to purchase the Lenham Mobile Commode from Aidapt. The Lenham Mobile
Commode is manufactured from the finest materials and components available, when used correctly it is
designed to give many years of reliable trouble-free service.
NB. This equipment must be installed by a competent person and a risk assessment may be
needed as to the suitability of the chair for the particular user.
165 kg (26 stone) weight limit.
Do not exceed the weight limit stated – doing so could put the user at risk.
BEFORE USE
Carefully remove all packaging. Avoid using any knives of other sharp instruments as this may damage
the surface of the product.
The commode is provided to you packed in cube form. Please examine all components for any visible
damage before use. If you see any damage or suspect a fault, please contact your supplier immediately.
NB. In this case, please do not use your product as it may compromise your safety.
ASSEMBLY
The package contains the following components:
•
The main frame with four brake castors attached
•
White commode plastic aperture seat (attached to the main frame)
•
Grey commode seat cover
•
A pair of detachable arms
•
Detachable back
Please read the following installation instructions carefully:
1.
Remove all contents from the box
2.
Place the assembled base on a level floor
3.
At the rear of the commode you will see two black threaded wheel nuts; undo the wheel nuts
so that the locking holes are clear
4.
Place the two back legs into the locating holes on the back edge of the commode frame
5.
Secure the back by turning the black lock nuts until you feel the nut biting against the back
leg.
6.
Do no over tighten
7.
Do not use tools as it is only necessary to have the back secured finger tight
8.
Place the two detachable arms into the four locating holes featured two each side of the
commode
COMPOSITION
The frame is made from chromium-plated mild steel. You must not, under any circumstances, use any
abrasive cleaners or cleaners which attach chromium plating.
FOOTRESTS (IF REQUIRED)
Footrests are supplied separately to the main commode. Please examine your footrests for any visible
damage before use. If you see any damage or suspect a fault, please contact your supplier immediately.
In this case, please do not use your product as it may compromise your safety.
1.
Remove the commode footrests from their packaging
2.
You will see on each of the front legs of the commode main frame about 150 mm high from
the castor 2 retaining lugs either side
3.
Take the footrests and align the holes in the inverted ‘U’ section with the lugs and lower
down into place.
