IR Remote Controller
6
Power
When powered on,pressing the power key enters standby
mode; Pressing it again will start up the camera and display
normally.
Freeze
(No Function)
The Freeze button has no function on the PTZ.
IRT
(IR Transfer/IR Pass)
Enables IR transfer. 0nce pressed, the camera will receive and
pass IR remote control signal (via VISCA IN
Port).
SET 1
~
4 Address Setting
Hold the SET# button for 3 seconds to set the cameras IR address.
CAM 1
~
4
(Camera selecting)
Pressing the CAM# button will enable IR control of the selected
camera.
Number Key
(1-9)
Set Preset: To set preset, hold down a key (0-9) and wait 3 seconds.
0ncecomplete, the selected preset will be saved.
Run Preset: Pressing a key (0-9)will bring up the corresponding
saved preset.
CLR PRE
(Clear Preset)
Clear a Preset :Press CLRPRE and key (0-9)simultaneously to
remove the corresponding saved preset.
Clear all Presets: Hold down CLRPRE button to remove all
saved presets.
Learn
This button is used with other remote buttons. It has no function
when pressed alone.
