13
(2) In case of TBX100F (D)
The direction of the display of this product can be freely adjusted to accommodate to the inlet
direction of the gas. In addition, the display can be detached to be used as a remote display.
1.
Remove the "bolt with a hexagon hole" located at the side of the display.
2.
A. Secure the mounting plate on a wall. (Use the attached screws.)
B. Rotate the counter 180 degrees.
C. Rotate the mounting plate 90 degrees to secure it. (Use the attached screws.)
3.
Secure the counter again.
The display can have an angle up to approximately 10 degrees.
A. Remote display
After installing the meter with the orientation
markings on the main body aligned to the inflow
direction of gas, follow the procedure above.
Inflow direction of gas
Direction to
recognize the display
Mounting plate
Mounting plate
Mounting plate
Mounting plate (to be rotated)
φ
3.2 mounting
screw hole
B. Right in
let
C
1
. T
op inlet
C
2
. Bottom inl
et
