AIC 12G SAS JBOD Series, Руководство пользователя

Страница: 68 / 112

59
J4060-03 User Manual Chapter 3. Sub-system Configuration Setup
3.6.5.5 How to enable/disable the enclosure alarm by your software
Enclosure control element
BYTE/BIT 7 6 5 4 3 2 1 0
0
COMMON CONTROL
SELECT PRDFAIL DISABLE
RST
SWAP
Reserved
1
RQST
IDENT
Reserved
2
POWER CYCLE
REQUEST
POWER CYCLE DELAY
3 POWER OFF DURATION
REQUEST
FAILURE
REQUEST
WARNING
The system alarm LED is used for the enclosure alarm and power alarm. The "REQUEST
FAILURE" and “REQUEST WARNING” for Enclosure are defined in the bit1, byte3 and bit0,
byte3 of the "Enclosure control element" in the SES specification. Setting either bit can
enable the enclosure alarm. Clearing both bits disables the enclosure alarm. We use the
software package "sg3_utils" on Linux for example, and have a SAS HBA and a cable to
connect your host with the expander.
(A) Show the device for AIC Expander Controller (canister)
$ sg_map -i
/dev/sg2 AIC 12G 4U60swap: Hub 0c07
(B) Enable the enclosure alarm
$ sg_ses --descriptor=EnclosureElement01 --set=3:1:1 /dev/sg2
or
$ sg_ses --descriptor=EnclosureElement01 --set=3:0:1 /dev/sg2
(C) Disable the enclosure alarm
$ sg_ses --descriptor=EnclosureElement01 --clear=3:1:1 /dev/sg2
and
$ sg_ses --descriptor=EnclosureElement01 --clear=3:0:1 /dev/sg2