Ahlborn ALMEMO 2390-3, Руководство по эксплуатации, Страница: 9 / 24

2. PUTTING INTO SERVICE
1. Connect transducer to socket M0 (2); see 4.
2. Provide power supply via 9-volt battery or mains adapter; see 3.1, 3.2.
3. To switch on , push the slide switch (1) located on the left side of the device
upwards; see 3.3; then read measured value; see 7.1.
4. To display measured values, return from
MAX
,
MIN
, or
HOLD
by pressing
M ▲
key; select measuring channels by pressing
M ▲
key (6); then
read measured values; see 7.1.
5. To freeze measured value, press
HOLD
key (6); see 7.3.
6. For reference measurement to a reference value or for sensor adjustment :
press
CLEAR
key (6); return to normal measured value by pressing and
holding down
CLEAR
key (6); see 7.4.
7. For differential measurement , insert two identical sensors in sockets M0
and M1 and then select measuring point M2; see 7.5.
8. Evaluating a measuring operation :
call up maximum / minimum values by pressing
MAX
or
MIN
key (6);
delete maximum and / or minimum values by pressing
CLEAR
key; see 7.2.
9. Programming or data output via interface :
Connect computer via interface cable to socket A1; see Manual, 5.2.
Activate supplied software AMR-Control.
Via ‘Setup interface’ set the COM port and transmission rate to 9600 bauds.
Program sensors via ‘Program measuring point list’ :
Measured value display and sensor adjustment via ‘Measuring points - Mea-
sured values’ Data logging in the computer :
- program the print cycle via ‘Devices - Programming’;
- open the terminal window via 'File - Terminal';
- open file via ‘File - Open’ and enter file name;
- start measuring operation by means of command button ‘Start’;
- stop measuring operation by means of command button ‘Stop’;
- close file via ‘File - Close’.
ALMEMO

2390-3 9
Putting into service