Version October 2015
6
EN
agru EF 110-B User’s Manual
2.3 Safety Messages and Information on Remaining Risk
Protect the power supply cord from cutting edges. Have an authorized
service shop replace damaged cables or lines immediately.
The machine has to be operated with a 230 V, 50/60 Hz power supply with
safety fuse or breaker of 16 A maximum. If power is connected through
a power line manifold, the power supply has to feature an earth-leakage
circuit breaker.
Use only extension cables with the following conductor sections:
– max. length of cable 25 m (80 ft) min. section 2.5 mm²
– max. length of cable 50 m (160 ft) min. section 4.0 mm²
Caution
Parts Under Power
After opening the machine or removing the cover, parts of it
are accessible that may be under power. The machine may be
opened exclusively by an authorized service shop.
Caution
Facing Tool
Never switch the facing tool on when it is not in its regular
working position. When working with the facing tool, do not
wear any jewellery and put on a hair snood or net as needed.
Removing the shavings from the work area while the facing
tool is running, is prohibited. Make sure nobody is present in
the danger zone.
Caution
Electrofusion Fitting
A welding process must never be repeated with the same fit-
ting, since this may cause parts under power to be accessible
to the touch.
Caution
Checking the Product for Damage
Before every use of the product, check safety features and
possibly existing parts with minor damage for proper function.
Make sure that the push-on connection terminals work properly,
that contact is fully established, and that the contact surfaces
are clean. All parts have to be installed correctly and properly
conform to all conditions in order for the product to function as
intended. Damaged safety features or functional parts should be
properly repaired or replaced by an approved service shop.
Caution
Acceptable Work Conditions
The work zone has to be clean and has to have proper lighting.
It is dangerous to operate in a humid environment or close to
flammable liquids.
The electrofusion fitting manufacturer’s installation instructions
and all applicable rules and regulations have to be respected in
all cases. Acceptable work conditions have to be ensured (e.g.,
sufficient distance between the machine and other functional
areas of the workshop).
Overhead work is prohibited, unless:-
• the machine is safely and securely fastened and positioned;
• access to a large area around the worksite is controlled/limited
•
(risk of falling objects); see also Sect. 2.5;
• a hardhat and safety goggles are worn (risk of falling objects and
•
small blades of shaving during component facing)
Important
Power Supply Only through Line with Protective Grounding
Conductor
The system has to be operated exclusively with a power supply
line equipped with a protective grounding conductor, as a power
