2
Parts included:
The above diagram shows only parts that are included in
the Command-10
®
remote control kit. All other parts shown in the following
instructions would be found in a new electric kit or would be already installed
on an existing electric system.
Control Box
Remote
Bolts, Washers
and Nuts
Terminals
Heat Shrink
Rubber
Boots
Dielectric
Grease
Packet
Wiring Instructions
Parts Diagram
(for part No. 80300)
STEP 1
Note: There is ample heavy gauge wire supplied with each kit for
standard installs. Before cutting wire, always preplan wire routing and
make necessary adjustments as needed.
Note: Use dielectric grease (packet included) at all electrical
connections throughout installation.
50 amp
Breaker
