AGP EB24R, Инструкция по эксплуатации

Страница: 6 / 12

6
UNPACKING
Carefully remove the tool and all loose items from
the shipping container.
Retain all packing materials until after you have
inspected and satisfactorily operated the machine.
CARTON CONTENTS
1.
M3 L-hex Wrench
2.
M8 L-hex Wrench
3. M24 x 27 Double Open-End Wrench
4.
M22 Open-End Wrench
5. M32 Open-End Wrench
DO NOT OPERATE THIS TOOL UNTIL YOU READ
AND UNDERSTAND THE ENTIRE INSTRUCTION
MANUAL.
SETTING THE CHAMFER HEIGHT
-
DISCONNECT TOOL FROM POWER SOURCE.
1. Loosen the 2 Depth lock screws of both sides
with supplied M8 Hex. Wrench.
2. Turn the Depth adjustor knob clockwise or
counter-clockwise to adjust to the desired
chamfering height. Please refer to the scale
on the side of the machine, maximum
chamfering depth up to 12mm at 45 deg.
3. After making sure the chamfering blades are
set to the desired height, fasten the 2 Depth
lock screws.
CHANGING THE INDEXABLE CARBIDE
INSERTS -
DISCONNECT TOOL FROM POWER
SOURCE.
WARNING: Danger of Burns! Tool holder and
carbide inserts become hot in operation. Wear
gloves and take precautions to prevent burns
when working with this part of the machine.
Note: indexable carbide inserts have multiple
edges. When one edge is dull simply rotate to
the next sharp edge. Once all edges are dull,
replace with new inserts.
NOTE: Make sure the indexable carbide inserts
are installed in the correct direction, incorrect
installation of indexable carbide inserts can
cause the failure of chamfering or even rupture
of the tool holders or the indexable carbide
inserts. Please refer to the front of the machine
for the rotation direction, and install the
indexable carbide inserts accordingly.
Arrange the tool holder milling discs in a
staggered orientation, in order to achieve
better beveling result.
1. Loosen the 2 Depth lock screws and fully
unscrew and remove the support deck
assembly.
2. Use the supplied M32 combination wrench to
secure the spindle.
3. Use the supplied 27mm x 24mm wrench to
unscrew the nut in front of the tool holder
and loosen the tool holder from spindle.
4. Rotate, remove or replace the tool holders as
needed.
5. Using the supplied M3 Hex wrench, loosen
fixing screw and remove the carbide inserts.
6. Rearrange the carbide insert to the other
sharp edge or insert a new one as needed.
7. Fasten carbide inserts.
Depth lock screw
Chamfer height scale