AGP EB24R, Инструкция по эксплуатации

Страница: 7 / 12

7
remove the rollers and unscrew the wedge nuts
from the rollers. Place the wedge nuts in the slots,
put the flat washers on the rollers and first screw
them in finger tight. Now match the machine to
the pipe and adjust the rollers so that they are
contacting the outside of the pipe. Now tighten
the rollers. Every time you bevel a different sized
pipe, you must readjust the rollers to match the
circumference of the pipe.
When returning to plate beveling mode, screw the
wedge nuts onto the rollers so that they will act as
spacers.
OPTIONAL LARGE PIPE BEVELING
TABLE PLATE
For even larger diameter pipes, there is an optional
large pipe beveling table plate which can bevel
pipes 300mm up to 600mm. Simply unbolt the
four socket cap screws to remove the standard
table plate and bolt on the optional table plate in
its place.
STARTING AND STOPPING TOOL
Make sure that the power circuit voltage is the
same as that shown on the specification plate of
the machine and that switch is “OFF” before
connecting the tool to the power circuit.
INSTALLING THE MILLING DISCS
Note: There are two different lengths of Milling
Receiver supplied with the machine. Use the
long Milling Receiver for 0 deg. facing off and
use the short Milling Receiver for other angles.
1. First install the desired Milling Receiver to the
spindle
2. Add the first Milling Disc, noting the correct
orientation. Since the spindle rotates in the
clockwise direction when viewed from the
spindle end, the cutting faces of the carbide
inserts should be facing the right.
3. Add the Intermediate Washer (with the
keyway).
4. Add the second Milling Disc, orienting it so
that it is staggered 90 degrees relative to the
first Milling Disc.
5. Finally add the washer and nut and tighten
the nut firmly.
ADJUSTING THE BEVEL ANGLE
Loosen the two Angular Adjustment Screws using
the L-hex wrench and adjust to the desired bevel
angle. Then retighten the screws.
Refer to the angle scale on the body of the
machine.
It may be necessary to readjust the depth
adjustment after changing the bevel angle. (See
above-"Setting the chamfer height")
SWITCHING FROM PLATE BEVELING
TO PIPE BEVELING MODE
The Table Plate has two possible modes. For plate
beveling, keep the rollers mounted in the fixed
position. (For full plate beveling depth, the rollers
may be removed)
For beveling of pipes 150 to 350mm diameter,
Hex. Wrench
Angular Adjustment Screw