AGP AC023, Инструкции по безопасности

Страница: 15 / 36

15
Work in sections within your reach. When painting
corners, point the gun parallel to the corner. Cut in
edges and corners first. Then paint flat areas.
Do not allow the material to run out.
Remember
to follow the PRESSURE RELIEF PROCEDURE
before refilling material.
If the material does run
out, the pump will suck in air. This air must be bled
out before continuing. Follow the instructions for
“Priming” above.
TO REMOVE CLOGS FROM SPRAY TIP
(reversible tips)
1.
Lock gun safet y latch and follow the
PRESSURE RELIEF PROCEDURE.
2. Turn Tip handle 180 degrees.
3.
Disengage trigger lock & trigger gun into
pail.
4. If the Tip handle appears locked loosen the
retaining nut. The handle will now turn easily.
5.
Engage gun safety latch & return tip to the
spray position.
CLOGGED FLAT TIP
If you are using a flat tip and the spray tip becomes
clogged, relieve pressure from hose by following
the
"PRESSURE RELIEF PROCEDURE."
Secure
gun with the safety latch, take off guard, take out
the tip, soak in appropriate solvent & clean with a
soft brush. (Do not use a needle or sharp pointed
ALL MODELS
While spraying, consistently hold the gun
perpendicular, about 25-30cm (10-12 inches) away
from the surface. Do not swing the gun. Do not tilt
the gun.
Trigger the gun before moving and release the
trigger after each stroke. Overlap each previous
stroke by half. Do this by aiming the tip to the edge
of the previous stroke.
Air Pressure Regulator Knob
Even coat throughout
RIGHT
Approximately
10 to 12 inches
WRONG
Light Coat
Heavy Coat Light Coat
Do not flex wrist while spraying
Forward position
(for spraying)
Reversed position
(for clearing clogs)
Never attempt to spray
with the tip in any
position other than fully
forward or fully reversed.