AGP AC023, Инструкции по безопасности

Страница: 9 / 36

9
grounding plug, and a receptacle that will
accept the grounding plug on the product.
Make sure your extension cord is in good
condition. When using an extension cord, be
sure to use one heavy enough to carry the
current your product will draw. If in doubt, use
the next heavier gauge.
2. Fluid hose:
use only grounded hoses.
3. Spray gun or dispensing valve: grounding
is obtained through connection to a properly
grounded fluid hose and pump.
4. All solvent pails must be conductive metal
material and properly grounded. Do not
place on a non conductive insulating
surface unless a ground wire is added to a
true earth such as a metal water pipe.
ALWAYS ensure fire extinguishing equipment is
readily available and properly maintained.
FLUSHING SAFETY
WHEN SPRAYING & CLEANING WITH FLAMMABLE
PAINTS AND THINNERS
1.
When spraying with flammable liquids,
the unit must be located a minimum of 25
feet away from the spraying area in a well
ventilated area. Ventilation must be sufficient
enough to prevent the accumulation of
vapors.
2.
To eliminate electrostatic discharge, ground
the spray unit, paint bucket & spraying object.
See
GROUNDING. Use only high pressure
airless hoses approved for 3000 psi which is
conductive.
3. Remove the spray tip before flushing. Hold
the metal part of the gun firmly to the side
of a metal pail & use the lowest possible fluid
pressure during flushing.
4. Never use high pressure in the cleaning
process. USE MINIMUM PRESSURE.
5.
Do not smoke in spraying/cleaning area.
NEVER use cleaning solvents with flash points
below 140 degrees F. Some of these are: acetone,
benzene, ether, gasoline, naptha. Consult your
supplier to be sure.
ASSEMBLY
Tools needed: Two adjustable wrenches-not
included.
1. Attach the hose to the pump and tighten
with a wrench.
2.
Attach the hose to the gun and tighten with
two wrenches.
AIR-ASSISTED AIRLESS MODELS ONLY
A
fter installing the fluid side of the bonded fluid
and air hose, Attach the air side of the hose.
Air Coupling
Air Inlet Fitting
Material Hose
Material Inlet
Fitting
Air whip hose
material Hose
Air Hose