AGP 700W Mechanical, Инструкция по эксплуатации

Страница: 9 / 24

9
accordance with all local codes and ordinances.
WARNING - Improper installation of the
grounding plug can result in a risk of electric
shock.
If repair or replacement of the cord or plug is
necessary, do not connect the green grounding
wire to either flat blade terminal. The wire with
insulation having a green outer
surface with or without yellow stripes is the
grounding wire and must be connected to the
grounding pin. Check with a qualified electrician or
serviceman if the grounding instructions are not
completely understood, or if you are in doubt as
to whether the product is properly grounded. Do
not modify the plug provided. If the plug will not
fit the outlet, have the proper outlet installed by a
qualified electrician.
IMPORTANT:
use only a 3-wire extension cord
that has a 3-blade grounding plug and a 3-slot
receptacle that will accept the plug on the product.
Make sure your extension cord is in good condition.
When using an extension cord, be sure to use one
heavy enough to carry the current your product will
draw. an undersized cord will cause a drop in line
voltage resulting in loss of power and overheating.
a 12 gauge cord is recommended. If an extension
cord is to be used outdoors, it must be marked with
the suffix W-A after the cord type designation. For
example, a designation of SJTW-A would indicate
that the cord would be appropriate for outdoor use.
OPERATION
Before beginning always check and tighten all
fittings securely.
WARNING: A loose connection could burst loose
under pressure causing a hazardous condition.
Ensure that all connections are tight. This
includes both ends of the hose, the gun filter, the
tip guard, the pump filter, and the suction tube
gland nut
WARNING:Always ensure that the gun safety
latch is in the locked position.
The gun safety latch should always be set. The only
time the trigger should be unlocked is when the
gun is actually being triggered.
Leave the tip out of the gun when priming, flushing
and cleaning.
Lubricate the packings: Fill the packing nut/wet
cup with about 2-3 drops of throat seal oil.
Prepare at least three buckets
The first bucket will hold the material to be sprayed.
The second bucket will hold flushing fluid, which
will be either mineral spirits (for oil-based materials),
lacquer thinner (for lacquers), water (for water based
materials), or soapy water (for converting from oil-
based or lacquer to water-based materials).
The third bucket will be the waste bucket.
FLUSHING
When to flush the pump
1. When the pump is filled with storage fluid,
as when you are operating your new airless
sprayer for the first time, or taking out of
storage. Flush with mineral spirits. (If you plan
to use water-based material see part 2 below.)
2.
When changing between oil-based and water-
based materials. First flush with mineral spirits,
followed by a soapy water flush, followed by a
clear water flush.
3.
When changing between water-based and oil-
Gun Trigger
Gun safety latch
Lock
Unlock