AGP 700W Mechanical, Инструкция по эксплуатации, Страница: 7 / 24

7
SPRAY GUN SAFETY
• ALWAYS
set gun safety lock in the "LOCKED"
position when not in use & before servicing or
cleaning.
• NEVER remove or modify any part of the gun.
• ALWAYS
REMOVE THE SPRAY TIP when
cleaning. Flush unit at the LOWEST POSSIBLE
PRESSURE.
• ALWAYS check operation of all gun safety
devices before each use.
• Be very careful when removing the spray tip
or hose from the gun. A plugged line will
contain fluid under pressure. If the tip or line is
plugged, follow the pressure relief procedure
TIP GUARD
• ALWAYS
have the tip guard in place on the
spray gun while spraying. The tip guard alerts
you to the injection hazard and helps prevent
accidentally placing your fingers or any part of
your body close to the spray tip.
SPRAY TIP SAFETY
• Use extreme caution when cleaning or
changing spray tips. If the spray tip clogs
while spraying, engage the gun safety latch
immediately. ALWAYS follow the
PRESSURE
RELIEF PROCEDURE
and then remove the
spray tip to clean it.
• NEVER wipe off build up around the spray tip.
TOXIC FLUID HAZARD
• A LWAYS remove tip guard & tip to clean
AFTER pump is turned off and the pressure is
relieved by following the
PRESSURE RELIEF
PROCEDURE.
• Hazardous fluid or toxic fumes can cause
serious injury or death if splashed in eyes or on
skin, inhaled or swallowed. Know the hazards
of the fluid you are using. Store & dispose of
hazardous fluid according to manufacturer,
local, state & national guidelines.
• ALWAYS
wear protective eyewear, gloves,
clothing and respirator as recommended by
fluid manufacturer.
HOSES
• Tighten all of the fluid connections securely
before each use. High pressure fluid can
dislodge a loose coupling or allow high
pressure spray to be emitted from the
coupling and result in an injection injury or
serious bodily injury.
• Only use hoses with a spring guard. The spring
guard helps protect the hose from kinks or
other damage which could result in hose
rupture and cause an injection injury. Do not
allow kinking or crushing of hoses or allow it
to vibrate against rough, sharp or hot surfaces.
• Use only conductive fluid hoses for airless
applications. Be sure the gun is grounded
through the hose connections. Use only high
pressure airless hoses with static wire which
are approved for 3000 psi.
• NEVER
use a damaged hose, which can
result in hose failure or rupture and cause an
injection injury or other serious bodily injury
or property damage. Before each use, check
entire hose for cuts, leaks, abrasions, bulging
of the cover, or damage or movement of
couplings. If any of these conditions exist,
replace the hose immediately.
• NEVER use tape or any device to try to mend
the hose as it cannot contain the high pressure
fluid.
NEVER ATTEMPT TO RECOUPLE THE
HOSE. A high pressure hose is not possible to
recouple.
GROUNDING
• Ground the sprayer & other components in the
system to reduce the risk of static sparking, fire
or explosion which can result in serious bodily
injury and property damage. For detailed
instructions on how to ground, check your
local electrical code.
• ALWAYS ensure switch is in OFF position
before plugging unit in.