AGM Global Vision VICTRIX, Руководство пользователя

Страница: 13 / 36

13 Victrix
USER MANUAL
3. Unlock the clamping device (A) of the Victrix mount by pushing down on the lever holder (B, see
Figure 2-4) and unlocking the cam lever (C).
4. Install the Victrix on the Picatinny/Weaver rail in front of the day scope so that the stop (E, see
Figure 2-2) slides into one of the rail’s transverse slot. The light suppressor should cover the day
scope’s objective lens.
5. Affix the Victrix to the rail by locking the cam lever (C, see Figure 2-4).
6. Verify that the clamping device is firmly secured to the Victrix. If necessary, adjust the clamping
device as detailed in Part 2.1.3 (Clamping Device Adjustment).
2.1.3 CLAMPING DEVICE ADJUSTMENT
To adjust the mount’s clamping device, do the following (refer to Figure 2-5):
1. Unlock the clamping device and remove the Victrix from the weapon.
2. To tighten/loosen the clamping device (B), push the cam (C) towards the arrow, which will cause
the nut (A) to slide out of its hole. Turn the nut (A) CW/CCW respectively, in one-two increments
(see note below). Backward-moving springs will cause the nut (A) to slide back into the hole.
NOTE:
The eight-sided nut of the clamping device will only fit into the hole if turned in one of the discrete
positions using increments equal to 360°/8.
3. Verify that the adjusted clamping device is firmly secured to the Victrix.
FIGURE 2-4. MOUNT. TOP VIEW
C
B
LOCKED POSITION UNLOCK POSITION
A
FIGURE 2-5. MOUNT. UNDERSIDE VIEW
LOCKED POSITION UNLOCK POSITION
A
B
C