12
AGM Global Vision
2.1.2 INSTALLING THE VICTRIX ON A PICATINNY/WEAVER RAIL
WARNING:
Always make sure your firearm is unloaded before you place the equipment on the firearm.
Always verify that the chamber is empty, especially if you stop the procedure and resume later.
Safe handling rules should be followed at all times.
WARNING:
AGM recommends that you use an eyecup on the day scope’s eyepiece for maximum safety and
comfort, as well as to escape detection.
NOTE:
The optical axes of the Victrix and day scope should be aligned. The distance between the axes
should not exceed 3 mm. If the difference in the axis heights of the Victrix and day scope above the
weapon rail exceeds 3 mm, you will need to replace the day scope mounting rings or monoblock.
The Victrix comes fully assembled with a Picatinny/Weaver mount (Figure 2-2).
The mount is (A) coupled with a riser (B) and attached to the Victrix seating rail (C) with two M4×20
flathead socket cap screws (D).
Figure 2-3 shows the Victrix mounted in front of a day scope.
To install the Victrix on a Picatinny/Weaver rail, do the following:
1. Unscrew the output lens cap and place it in the storage case.
2. Remove the light suppressor from the storage case. Screw it into the thread of the output lens
in place of the cap.
FIGURE 2-2. THE VICTRIX FULLY ASSEMBLED WITH THE MOUNT
A
B
E
C
D
FIGURE 2-3. THE VICTRIX ON A PICATINNY RAIL IN FRONT OF A DAY SCOPE
Содержание VICTRIX
Страница 1: ...USER MANUAL VICTRIX THERMAL IMAGING CLIP ON SYSTEM...
Страница 34: ...34 AGM Global Vision NOTE...
Страница 35: ...35 Victrix USER MANUAL NOTE...