9
Speaker Microphone Battery Lid (0607-59-002)
The Speaker Microphone Battery Lid (pictured below) incorporates a speaker and microphone to allow the
two-way audio functionality of the FL360. This lid is held in place by two captive stainless-steel screws and
must be hand-tightened securely and evenly into place. The Speaker Microphone Battery Lid is water resistant
for rain, water spray, and accidental dunking (IP67). If you wish to use the FL360 Camera under water,
exchange the Speaker Microphone Battery Lid with the Environmental Battery Lid.
●
Ensure that the gasket on the interior face of the Speaker Microphone Battery Lid is in good condition, free
from debris, and contains no nicks or cuts that could negatively affect the seal.
●
Flush out any debris from the speaker grill by removing it from the camera and running it under a flow of
clean water. Shake out all the water from the lid and allow to dry thoroughly before reinstalling.
WARNING:
Do not stick anything into the speaker grill or microphone port, as doing so might puncture the
diaphragm causing a leak which will damage the FL360
camera’s interior
electronics.
Speaker Microphone Battery Lid
–
interior face
Speaker Microphone Battery Lid
–
exterior face
