Agilent Technologies 86121A, Руководство пользователя, Страница: 111 / 240

4
-
44 Lists of Commands
:CALCulate3:DELTa:REFerence
:FREQuency Selects the signal to be used as the reference
for the DELTa calculations. I
:CALCulate3:DELTa:REFerence
:POWer? Queries the power level of the reference sig-
nal. I
:CALCulate3:DELTa:REFerence
[:WAVelength] Selects the signal to be used as the reference
for the DELTa calculations. I
:CALCulate3:DELTa:WAVelength
[:STATe] Turns the delta wavelength measurement
mode on and off. I
:CALCulate3:DELTa:WPOWer
[:STATe] Turns the delta wavelength and power mea-
surement mode on and off. I
:CALCulate3:DRIFt:DIFFerence
[:STATe] Sets the drift calculation to subtract the mini-
mum values measured from the maximum val-
ues measured. I
:CALCulate3:DRIFt:MAXimum
[:STATe] Sets the drift calculation to return the maxi-
mum power (frequency) values measured. I
:CALCulate3:DRIFt:MINimum
[:STATe] Sets the drift calculation to return the mini-
mum power (frequency) values measured. I
:CALCulate3:DRIFt:PRESet Turns off all the drift states for DIFFerence,
MAXimum, MINimum, and REFerence. I
:CALCulate3:DRIFt:REFerence
:RESet Places the current list of signals into the refer-
ence list. I
:CALCulate3:DRIFt:REFerence
[:STATe] Turns the drift state on and off so that
CALC3:DATA? will return the reference signal
list. I
:CALCulate3:DRIFt[:STATe] Turns the drift measurement calculation on
and off. I
:CALCulate3:POINts? Queries the number of points in the data set. I
:CALCulate3:PRESet Turns off any CALCulate3 calculation that is
on. I
DISPlay Subsystem
:DISPlay:MARKer:MAXimum Sets the marker to the signal with the largest
power. I
:DISPlay:MARKer:MAXimum:LEFT Moves marker to signal with the next lower
wavelength or frequency. I
Table 4-7. Programming Commands (3 of 5)
Command Description Code
Codes: S indicates a standard SCPI command. I indicates an instrument specific command.