Agilent Technologies 5530, Руководство по началу работы

Страница: 58 / 150

Chapter 4 Using the Agilent 5530 for the First Time
Task 4: Making the Measurements
4-14 Getting Started Guide
4
2 In the Travel Mode box, select Unidirectional.
3 In the Start Position field, type 0, which stands for 0 mm; this is the
position you will move the retroreflector to first. To enter information in a
field, first select the field, then type the information.
(If entering a new value produces an error message about inconsistent
targets, it means that other values in the list must also be changed. You
can select Recalc. Parameter to determine values that are consistent with
the one you entered.)
4 In the End Position field, type 75.
The value 75 mm is the position you will move the retroreflector to last.
5 In the No. of Points per direction field, type 4.
The value 4 represents the number of measurements you will make,
beginning with the start position (0).
You do not need to fill in the interval; the software calculates the interval
from the start and end position and number of points.
6 In the No. of Cycles field, type 1.
The value 1 is the number of times you will make the three
measurements.
7 Select Collect Data.
The Collect Data: LINEAR screen is displayed (Figure 4-9). This screen is
used to record measurements and access other functions, such as
analyzing data.