AGCO MASSEY FERGUSON 7380 CENTORA Combine Series, Руководство по ремонту

Страница: 40 / 41

40 MF7380 - MF7382 CENTORA - EAME
D3117800M2 - S/N 582 582 583 583400001
1
1. Introduction - Specifications
Crop_this_page
1.5.3 Instruction of combine operator
T019994
The customer or combine operator must be instructed in the basic principles of the combine and its opera-
tion.
This instruction must include the following:
– Basic principles of the combine
– Functions and instruments.
– Safety precautions
– Driving the combine
– Use of TechTouch.
– Initial harvest settings
– Harvesting technology and optional equipment
– Routine maintenance
– Off-season storage
– Right to free service
– Legislation with regard to yieldmeter source
This instruction must be given in the presence of everyone who will be involved in the operation and main-
tenance of the machine.
All points must be explained in detail and run through with the customer where relevant for the combine
model in question - special attention must be drawn to all points relating to safety during operation and main-
tenance.
1. Stress the importance of all the safety guards being in place when the machine is in operation, and dem-
onstrate how to open and close the guards on both sides of the machine.
2. Explain the use of the cutting table’s safety stop, and how important it is for the engine to be stopped
when work is being done on the machine.
3. Explain the importance of switching the engine off when working on the machine.
4. Explain about the yield meter.
5. Show where the main switch is located and how to operate it, and point out how important it is to use it
to turn off the machine’s electrical system.
6. Explain how to use the operator’s manual and other technical manuals supplied with the machine, and
show where they and the toolbox are kept.
7. Point out the importance of the serial numbers for the combine, cutting table and engine, and show
where the numbers are located.
8. Explain how to adjust the steering wheel and operator seat.
9. Demonstrate the following instruments in the operator cab:
– Switches in the cab roof panel.
– Show how to clean the cab air-filter and how to use the blower/heating system/air-conditioning/recir-
culation.
– Windscreen wiper
– Work light and unloading auger light.
10. Explain the use of the rotating yellow beacon and hazard light.
11. Show the grain tank light/adjustment of the grain tank auger cover plate/grain tank covers, electrical/man-
ual opening, and level sensor.
12. Explain that the multi-function lever must be in neutral position when the engine is being started and
stopped.
13. Explain operation of the throttle lever and point out that the engine must run at max. speed during har-
vesting.
14. Demonstrate how to start and stop the engine when it is both hot and cold.
15. Explain about transport lights, direction flashers, hazard light and horn