MF7380 - MF7382 CENTORA - EAME
39
D3117800M2 - S/N 582 582 583 583400001
1
1. Introduction - Specifications
Crop_this_page
22. Check hydraulic connections for leaks. Repair if necessary.
23. All belts and chains.
24. Seals for stone trap/main grain pan and shaker shoe.
25. Function and setting of straw chopper clutch.
26. Tightening of bolts in wheels and undercarriage in accordance with operator’s manual.
27. Tyre pressure in accordance with operator’s manual.
BEFORE STARTING THE ENGINE
Turn on the ignition and check:
28. Lights – main lights, direction flashers, warning lights and horn.
29. Operation of TechTouch.
STARTING THE ENGINE
Start the engine and check:
30. Cooling water temperature sensor.
31. Operation of accelerator.
32. That the fuel stop function stops the engine.
WHILE THE ENGINE IS RUNNING
do the following:
The combine must be kept under constant observation and checked for faults/leaks during this testing.
33. Check the threshing unit and cutting table at low speed. Then let the threshing unit run for 30 minutes at
max. speed and check all the functions. The reel should run at half speed.
34. Check table reversing at low engine speed.
35. Check operation of hydrostatic transmission, speed control/gearshift and brakes.
36. Check all electrical/hydraulic functions/control systems.
37. Check mechanical/electric clutches.
38. Check max./min. speed of reel/threshing cylinder and fanning mill.
39. Check engine and straw walker speed.
40. Check that preset cutting height is in accordance with TechTouch. Zero and then set to 10 cm cutting
height.
41. Calibrate cutting height control and set to 10 cm cutting height.
42. Check field pressure control and set to 5 bar below the actual pressure for 10 cm cutting height.
43. Calibrate operation of Auto Level combine and table (if fitted).
44. Check pre-set cutting height/cutting height control and field pressure control.
45. Check operation of optional equipment, vertical knife/chaff spreader/straw chopper/electric straw deflec-
tors/chopper vibration sensor and returns volume sensor (if fitted).
46. Calibrate Constant Flow. Set sensitivity to 12, response to 5 and cylinder load to 4.5.
FINAL CHECK
When the engine has been stopped, do the following:
47. Check that there are no oil, fuel, DEF or coolant leaks.
48. Check the machine for any loose nuts, bolts, etc.
49. Remove all preservatives and shipping labels.
50. Clean the combine.
51. Check that all the safety guards are fitted.
52. Check that the contents of the toolbox and the technical manuals are in accordance with the specifica-
tions.
