MF7380 - MF7382 CENTORA - EAME
33
D3117800M2 - S/N 582 582 583 583400001
1
1. Introduction - Specifications
Crop_this_page
When fitting a new hose, you should connect both ends loosely and make sure that the hose takes up the
desired position before tightening the connections. Clips should be done up tightly enough to hold the hose
without squeezing it and to prevent rubbing or contact with other parts.
Before removing hoses or pipes, make sure that you identify them in such a way that they can be reassem-
bled correctly.
Make sure that the hoses fitted have no kinks or twists after fixing.
Bearings
Bearings that are considered suitable for further use should be cleaned in a suitable solvent and put in clean
lubricating oil until they are used.
Do NOT rotate bearings using compressed air. The centrifugal force can cause a ball or roller to fly outwards
with enough force to cause injury.
Fitting a bearing can be classified in two ways: Press fit on rotating parts such as shafts and gears, for exam-
ple, and push fit into static places such as a gearbox reduction. Where possible, you should always fit the
bearing on the rotating component first.
Always use pullers or a press to remove and/or fit bearings, bushes and cylinder sleeves, etc. Use a hammer,
punch or chisel only when absolutely necessary and remember to wear safety glasses.
Shim rings
When removing shim rings, tie them together and identify them with regard to their location. Keep them
clean and flat until they are refitted.
Cables and wires
When dismantling or disconnecting a group of cables or wires, each of them must be labelled to ensure they
can be connected correctly again.
Always cut ducts and conduits back properly to prevent rubbing, cable damage and possible fire damage.
