7
Model 450
Locate parts bag 7. Attach legs part #001-
4703B to the tank saddle with 3/8 x 1” bolts, flat and lock washers.
The legs will attach on top of the bale chamber in front of the hydraulic compression area. (Figure 1) You will
need to drill four 1/2 inch (13 mm) holes on top of the chamber to mount the tank and frame. Clamp legs on
top of the bale chamber, mark the holes and drill. The 1/2 x 1-
3/4” inch allen head carriage bolts will be
inserted through the bale chamber along with flat washers so that the carriage head will be inside of the
chamber. Secure the allen head carriage bolts with 1/2 nuts, flat and lock washers. Mount the supplied
support bracket to the bottom of the tank saddle and to the baler frame as shown below.
Figure 1
Mount support bracket
(001-4424C) at these
locations. Two tie
models only.
For AGCO part cross-reference visit: www.harvesttec.com/system.html
