AGCO GSI 40 Series, Руководство по монтажу, Страница: 112 / 164

Chapter 8: Roof Assembly
Figure 8-24 Cap plates assembly
R Side cap plate (CTR-1135), approximately
62.1 lb (28 kg) U 3/8 x 1-1/2 in. bolt with sealing washer (S-
7488)
S Bead of caulk
V
3/8 in. nut (S-9426)
T Center cap plate (CTR-1134), approximately
137.691lb (62.5 kg) W Eyebolt
17.Make sure the holes in the cap plates are aligned with the holes in the center collar assembly.
IMPORTANT: With numerous pieces, there may be possible variations in hole alignment and the
cap plates assembly may not align with a fully tightened and assembled center collar
on the roof. Hence, it is recommended that the center collar assembly, the center
collar channels with the center collar channel spacers and the cap plates are
assembled together on the ground into place before lifting the center collar assembly
onto the roof.
18.Tighten all the hardware to the recommended specifications to complete the assembly. See Bolt
Torque Specifications, page 22 .
19.Loosen and remove all the bolts securing the center collar channels and the center collar channel
clips.
20.Use the appropriate lifting device and qualified personnel to lift the cap plates and the center collar
channels as an assembly from the center collar assembly and keep it aside.
21.Remove the center collar and cap plates assembly (X) from the center collar assembly (Y) and
keep it aside at a clean place.
112 Pneg-4460A 60 Ft Diameter 40-Series Bins