17. Replace Module top plate as follows:
a) Support top plate at front and reconnect the wiring to the two neons.
b) Carefully lower the top plate into position taking care not to damge wiring or neons.
c) Ensure holes for controls spindles are aligned correctly, and replace 2 screws into control panel.
d) Loosely screw the top plate down with 4 retaining screws.
18. Verify that the two plates are level, then proceed with tightening down.
19. Fit the Module handrail bracket over the fixing stud located on the top plate. Lock into position by tightening the grub
screw nearest the appliance. (See Fig. 13).
Fig. 13
DESN 516855
20. Next, fit allthread stud into the insert located in the one end of the Module handrail, then feed the handrail through the
bracket and screw the handrails together. (See Fig. 14).
Fig. 14
DESN 516856
20
Содержание DC3M
Страница 24: ...Fig 15 DESN 511617 BURNER CAP RETAINING LUGS Fig 15A DESN 513513 DESN 513898 Fig 15B 24...
Страница 26: ...Fig 17 Fig 18 DESN 511649 DESN 511650 26...
Страница 29: ...AGA TC DC INTEGRATED MODULE GAS HOB CIRCUIT DIAGRAM 29...
Страница 31: ...31...
