AFRISO SonarFox UST 20, Руководство по эксплуатации

Страница: 17 / 38

17 AFRISO SonarFox UST 20
UNITS
The product can display and calculate a large number of physical quantities. The setting is made
in the "UNITS" menu.
MIN LEVEL
MAX LEVEL
UNITS
DAMPING
SENSITIVITY
TEACHING
UNITS
LEVEL
mm
DISPLAY: %
LEVEL: Unit selection (mm, cm, m, in, ft)
DISPLAY: unit shown on the display
(%, mm, cm, m, in, ft, l, hl, m3, gal, bbl,
mA)
1. Press the OK button to open the "BASIC SETTINGS" menu.
2. Use the arrow buttons to select the „UNIS“ and press OK.
3. Press the OK button and the arrow buttons to set the units.
4. Press the OK button to save the values.
5.
Press the ESC button to exit the menu. The product switches back to the measurement mode.
DAMPING
Setting of the echo velocity during the measurement. The function suppresses unstable display
with unsteady input of rapid or sudden level changes. (e.g surface turbulence). The subsequent
reaction time depends on the exponential curve. The damping with a defined delay in seconds
describes the period in which the exponential curve reaches 2/3 of its maximum value.
DAMPING
05
MIN LEVEL
MAX LEVEL
UNITS
DAMPING
SENSITIVITY
TEACHING
The damping time can be set in a range
of 0 to 99 s.
1. Press the OK button to open the "BASIC SETTINGS" menu.
2. Use the arrow buttons to select the „DAMPING“ and press OK.
3. Press the OK button and the arrow buttons to set damping in secunds.
4. Press the OK button to save the values.
5.
Press the ESC button to exit the menu. The product switches back to the measurement mode.
SENSITIVITY
Sensitivity level meter is defined in four steps:
• "LOW“ – reduced sensitivity in case of environmental disturbances which impair the measure -
ment.
• "MEDIUM“ – medium sensitivity (suitable for most applications).
• "HIGH“ – increased sensitivity ffor media that partially reduce the echo (foam).
SENSITIVITY
LOW
MIN LEVEL
MAX LEVEL
UNITS
DAMPING
SENSITIVITY
TEACHING
You can set the sensitivity in four de-
grees:
LOW – MEDIUM – HIGH.
1. Press the OK button to open the "BASIC SETTINGS" menu.
2. Use the arrow buttons to select the „SENSITIVITY“ and press OK.