2
TOOLS INCLUDED:
F
8 mm T-Wrench
F
5 mm T-Wrench
F
5 mm L-Wrench
F
Screwdriver
PARTS INCLUDED:
F
1 Console Assembly
F
2 Console Masts
F
2 Console Mast Caps
F
1 Handlebar Assembly
F
1 Hardware Kit
F
1 Safety Key
F
1 Power Cord
F
1 Heart Rate Chest Strap
F
1 Audio Adapter Cable
F
1 Passport Box
If you have questions or if
there are any missing parts,
contact Customer Tech
Support. Contact information
is located on the back panel
of this manual.
NEED HELP?
DO NOT ATTEMPT TO LIFT THE TREADMILL! Do not move or lift treadmill
from packaging until specified to do so in the assembly instructions. You may
remove the plastic wrap from console masts.
WARNING
UNPACKING
Place the treadmill carton on a level flat surface. It is recommended that you place a
protective covering on your floor. Take CAUTION when handling and transporting this
unit. Once the banding straps have been removed, do not transport this unit unless it is
fully assembled. Unpack and assemble the unit where it will be used. Never grab hold of
any portion of the incline frame and attempt to lift or move the treadmill. Lift the treadmill
from the roller end caps area while a second person removes the parts packed under
the treadmill.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY!
WARNING
NOTE: During each assembly step, ensure that ALL nuts and bolts are in place and
partially threaded in before completely tightening any ONE bolt.
NOTE: A light application of grease may aid in the installation of hardware. Any grease,
such as lithium bike grease is recommended.
PRE ASSEMBLY
BOLT (A)
20 mm
Qty: 6
SPRING WASHER (B)
8.2 mm
Qty: 6
ARC WASHER (C)
8.2 mm
Qty: 6
HARDWARE fOR STEP 1 :
BOLTS (A)
SPRING WASHERS (B)
LEFT CONSOLE MAST
LEAD WIRE
CONSOLE CABLE
ARC WASHERS (C)
MAIN FRAME BRACKET
RIGHT CONSOLE MAST
ASSEMBLY STEP 1
A Open
hardware for step 1
.
B Pull
lead wire
through
right console mast
.
After pulling the
lead wire
through the mast, the
top of the
console cable
should be located at
the top of the mast. Detach and discard
lead wire
.
N
C Attach
console mast
to
main frame
bracket
using 3
bolts (a)
, 3
spring
washers (b
) and 3
arc washers (c)
.
D Repeat step C on other side.
NOTE: Do not tighten bolts until step 3 is complete.
NOTE: Do not pinch console cable when placing
the mast onto the main frame bracket.
