Afag PEZ-100, Инструкция по техническому обслуживанию

Страница: 48 / 60

Seite 48 PEZ-52-65-80-100 BA-vers.1.3 gb
.
15.10.14.doc
4.1.1 Further maintenance
4.1.2 Lubrication of the linear guidance
WARNING
The gantry axis should be started up in set-up or jog mode.
Incorrect programming can trigger uncontrolled movements of
the gantry axis. Fast or unintentional movements of the module
can result in personal injury, even death, and damage to the
unit.
Ensure that the controller is switched off and secured against
being switched on again when working on the gantry axis.
Lubrication interval:
Every 2000 km or every 6 months to the carriage lubrication nipple (all 4) 2-3
bumps.
Lubricate at the carriage grease nipples (all) with 2-3 shots every 2 months.

Move the axis to a central position so that there is sufficient spacing between
the guide carriage and the limit stops to apply the grease gun.

Check whether the controller is switched off and secured against
restarting.

Remove old grease residues and dirt from the ends of the guide carriage with
a lint-free cloth

Recommended grease types: Blasolube 301
In order to distribute the lubricant evenly, 2
– 3 strokes should be executed at low
speed after greasing is completed.
Under the ambient conditions mentioned below, the axis does not require any
further maintenance:

clean workshop atmosphere

no splash water

no dust and fumes caused by abrasion or processes

ambient conditions according to the technical catalogue
Lubrication on both sides of the carriage