Fault elimination
Assembly instructions EN
GE-25-P
Date 02.11.2021
Version 1.0
37–48
8 Fault elimination
8.1 General Notes
This chapter contains general information and safety instructions for
troubleshooting for the GE-25-P.
8.2 Safety instructions for troubleshooting
Measures to be taken in the event of faults
•
Immediately take the GE-25-P out of operation and report the fault to
the responsible authorities/persons.
•
Have the fault rectified by trained personnel.
•
Do not put the GE-25-P back into operation until the fault has been
completely eliminated.
•
Check the GE-25-P after a malfunction to ensure that the functions of
the GE-25-P are still given and that no extended hazards have arisen.
Also observe the safety instructions in
chap. 2 „Safety instructions“ in this
manual.
8.3 Table Fault causes and remedy
The following table contains an overview of possible fault causes and how to
proceed to eliminate them.
8.3.1 Troubleshooting table
Fault
Possible cause
Remedy:
GE-25-P does not move
Base jaws jammed in housing,
e.g. because the flatness of the
mounting surface is insufficient
Sensor incorrectly adjusted /
sensor has become misaligned
Power supply incorrectly
connected
Check the flatness of the screwed-
on surfaces (
chap. 6.3)
Loosen fastening screws of the GE-
25-P and operate the gripper again.
Adjust the sensor so that it is not in
the travel path of the GE-25-P.
Distance to mechanics: 0.2 mm).
Check power supply (elec.
Connection - “Digital I/O” 30)
WARNING
Danger of injury due to improper work!
Poorly performed troubleshooting work can lead to serious injuries and
damage to property.
The due diligence obligations of the user include ensuring that personnel
working on eliminating faults appropriately trained and qualified.
