Installation, assembly & setting
Assembly instructions
EN
CS 16 - CS 20
Date 01.06.2021
Version 6.0
49–64
Adjustment to other action direction
6.10.1 Set the ZA-Catch to a different action direction
The basic setting on the ZA intermediate stop is factory-set for retraction of the
CS module. If the ZA intermediate stop is to be used for extension, the ZA-Catch
must be changed over. These activities are described below in chapter 6.10.2 .
Changing the acting direction of the ZA-Catch can be done in a simple way.
This activity must be performed before mounting on the CS module.
6.10.2 ZA-Catch to other acting direction (procedure for retraction or extension)
CAUTION
Danger of crushing!
When mounting a ZA intermediate position to an installed CS module, the
module or station must not be under pressure.
If possible, remove the CS module to avoid crushing the limbs.
Switch off the pneumatic system and use a lockout device to make sure
that the pneumatic cannot be switched on again.
1
2
3
4