55 000 015 – Ed. E
Mix2000 - User Manual
16
This document is the property of AETA and can not be duplicated without authorisation
February 2001
Manuel Mix2000 (E) - Ed. E.doc
4.2.2. Bottom side
For accessing the elements, remove all screws on the bottom and put the bottom cover aside
1
. The
motherboard appears as on the following picture. The jumpers are shown with the effect of each position.
Figure 9 – Internal configuration – bottom side view
Notes:
•
Slate signal insertion: the jumper must be set on one among the four allowed positions (or none of
them in order to disable the slate function). It is also allowed to select more than one position, as
the signal is injected on each output for which the corresponding jumper is set on.
•
Please also refer to following chapter 4.2.3 in case the mixer is equipped with a digital output.
•
Do not move other jumpers than those described above.
When remounting the cover, please check that the flanges are well engaged inside the cover grooves
before tightening the screws.
1 Caution: only remove one cover at a time.
