55 000 015 – Ed. E
Mix2000 - User Manual
8
This document is the property of AETA and can not be duplicated without authorisation
February 2001
Manuel Mix2000 (E) - Ed. E.doc
3.2.3. Monitoring section
Figure 5 – Monitoring section
Notes:
•
The “ON AIR” indicator is activated by the “On-air” control signal from the “Monitor” interface
(refer to 2.8, Monitor (MON));
•
The M/S switch can be used for optionally matrixing the signal for monitoring, typically for
listening in normal stereo when using M/S microphones (see 2.5, Monitoring). A red LED is on
when the switch is activated. In such case, the action of the mode selector is indicated by red
coloured text near the selector.
•
The LED above the power switch lights green when the unit is on. However, the LED flashes red
whenever the batteries are low (less than 8.8 V, or 1.1 V per battery), or the external DC power is
low (less than 12.8 V
1
).
•
The Slate button can be used for activating the talkback microphone. The microphone is located
behind a small cavity in the front panel, just besides the “Slate” button.
•
The button below the bar-graphs is used for adjusting the display mode and/or the display
brightness. The following chapter describes the instructions for using this button.
1 Note that the threshold is different for the external power
