AET AET111, Руководство по эксплуатации

Страница: 14 / 53

47113964.2.023РЭ
14
put value is used for the dividing of a constant stored in a microcontroller’s ROM. The dividing result is a
frequency output code.
1.4.5 The interface is implemented on the microcontroller and used to transducer data read transac-
tion from the upper level controller. The address space configuration and calculator settings are stored in
it.
The interface has two galvanic isolated outputs RS-485 by MODBUS-RTU, MODBUS-ASCII, IEC
60870-5-101 or «ExtDev» .
To make a user-configuration of the transducer, user can apply the program
«SetComplex 3.1 (EN)». (See the Annex B).
To configure the transducer and to confirm real values of the metrological characteristic, the user can
apply the «SetComplex 3.1 (EN)» и «ComplexMet 3 EN». (See the Annex B, C).
1.4.6 Power source consists of the supply transformer, rectifier units and integrated linear voltage
regulators.
1.5 Marking and sealing
1.5.1 The following information is marked on a cover of the transducer:

The name and type designation;

Manufacturer’s mark;

The nominal values of voltage and frequency of the supply;

The nominal values and unit symbols of input signals;

The value of maximum main power;

Frequency range of the input signal

The category of measurements;

Designation of numbers and purposes of terminals;

The sign ;

The sign «3~»;

Serial number and two last digits of Issue Year.

Inscription «Made in Russia»

The sign of conformity (granting the registered declaration conformity).
1.5.2 Sealing of the transducer is yielded with a bitumen mastic №1 (according to ГОСТ 18680-73)
applies on one cover screw out of four.
1.6 Packing
1.6.1 Transducers are delivered in distribution packaging.
1.6.2 The packing note is enclosed in the transport container.
1.6.3 The transducer is packaged into individual packing.
The passport and CD with software are inserted inside of the individual packing.