6
micro-Line saggital saw GD307
Aesculap Power Systems
6. Disassembling
6.1 Disassembling the handle part
¾
Unscrew fastening nut GB307207.
¾
Unscrew and remove countersunk screw TA007306.
¾
Set rocker complete GD307803 to central position.
¾
Remove sleeve GD307205.
¾
Remove retaining ring TA007307.
¾
Unscrew locknut GD307203. If necessary, warm up the locknut prior to
removal.
¾
Laterally turn rocker complete GD307803 out of its guide.
¾
Remove rocker complete GD307803, observing the ball component.
¾
Remove sheath GD307202.
¾
Unscrew handle part GD307201 from rear housing GD307227. Warm
up components, if necessary.
This completes disassembling of the handle part.
6.2 Disassembling the rear housing
¾
Pull connecting rod GD307210 with plunger GD307200 from gear
wheel GD307219.
¾
Press connecting shaft GD307218 from connecting rod GD307210 or
plunger GD307200, respectively.
¾
Remove shim GD307223.
¾
Pull radial ball bearing TA009542 off from connecting shaft
GB307218.
¾
Remove radial ball bearing TA009541 from connecting rod GD307210.
¾
Unscrew screw GD307226.
Drive unit complete drops out of the rear housing.
¾
Press out fastening shaft GD307224 from gear wheel GD307219, using
special device W-90000167 and special device W-90000169.
¾
Press out 2 bearings GD307225 from the rear housing.
This completes disassembling of the rear housing.
6.3 Disassembling the drive unit complete
¾
Expel pin GD307216 from drive unit complete GD307802.
¾
Take off coupling piece GD307228 and compression spring GD307217.
This completes disassembling of the drive unit complete.
7. Assembling
7.1 Preparations
¾
Clean all components, remove Loctite residues, and degrease.
7.2 Assembling the drive unit complete
¾
Insert compression spring GD307217 in coupling piece GD307228.
¾
Mount coupling piece GD307228 on drive unit complete GD307802
and secure with pin GD307216.
This completes assembling of the drive unit complete.
7.3 Assembling the rear housing
¾
Press 2 bearings GD307225 into rear housing GD307227.
¾
Insert fastening shaft GD307224 through the rear housing and press it
onto gear wheel GD307219, using special device W-90000168.
¾
Slide the drive unit complete in its correct position into the rear
housing and fasten it with special screw GD307226.
¾
Mount radial ball bearing TA009541 and radial ball bearing TA009542
on connecting rod GD307210.
¾
Slide in connecting shaft GD307218 from the chamfer side of
connecting rod GD307210.
¾
Install shim GD307223.
¾
Press plunger GD307200 onto the connecting shaft. Note the slanted
drill hole for steel ball TA003323 in rocker complete GD307803.
¾
Check for smooth running of the assembly.
¾
Press connecting rod GD307210 complete onto gear wheel GD307219.
¾
Check for smooth running of the assembly.
This completes assembling of the rear housing.
