AES uScope Manual
www.AESwave.com
Copyright 2011 by Automotive Electronics Services, Inc.
Page 3
o
Ports, Connection and On/Off Button
On/Off
The on off switch is located at the bottom right of the
unit. It is a slide switch.
Test Lead Port
The test lead connection is a 3.5mm stereo audio jack
located at the top left side of the unit. When connecting,
ensure that the plug is inserted to the base.
Note: The 3.5 stereo audio jack port located at the
bottom left of the unit is a signal generator.
DO NOT USE
THIS PORT WHEN TESTING AN AUTOMOTIVE CIRCUIT.
USB to PC Connection and Charging Port
The USB connector is a standard micro USB and is
located in the middle left side of unit. This port is used
for PC and uScope communication and for charging the
uScope.
Memory Card
– microSD Card
The uScope incorporates a microSD memory card. The
card port is located in the center of the bottom side of
the unit. Note that the electrical connection tabs face
toward you for installation. Press the card in until fully
seated. When properly installed the card will be just
below flush.
**Do not remove the memory card. Doing so may
disable the ability to save and recall setups.