AES uScope, Начало работы, Страница: 10 / 12

AES uScope Manual
www.AESwave.com Copyright 2011 by Automotive Electronics Services, Inc.
Page 10
 Press and hold “OK” button until prompt changes to the next numerical file
number - located in top right of screen.
 Press “OK” to exit the menu
Save to USER file
 Highlight “Save to user file”

Use LEFT/RIGHT to select file number to save. Note: filename at top right of
screen.

Press and hold
“OK” button until prompt at the top right of screen changes the file
number.

Press
“OK” to exit the menu
“CR”
Cursor Values

Highlight the
“CR” menu using the UP/DOWN arrow keys and press “OK”

Use UP/DOWN to Highlight the desired cursor (Cursor V1, V2, T1 T2)

Use LEFT/RIGHT to adjust cursor location. (Note: The cursor values are located
on the bottom left of the screen)

To turn cursors off.
o
Highlight either V1-V2 (vertical cursors) or T1-T2 (time cursors).
o
Use LEFT/RIGHT to toggle between ON/OFF.

Press “OK” to exit menu
“ME”
Measurements
Highlight the “ME” menu and press “OK” to activate the measurements value.

To turn off measurement values.
Use UP/DOWN and select “Enable On/OFF”

Use LEFT/RIGHT to toggle between ON/OFF

Press “OK” to exit menu
“OP”
Options
Highlight
the “OP” and press “OK” to activate the menu.
Probe Cal (Probe Calibration)

Highlight Probe Cal

At the top right of the screen, the uScope will specify what attenuation setting you
are currently on (Note: 10x does not change anything within the scope other than
the voltage settings will be 10x larger
– 1volt per division will read 10 volt per
division.

Use the LEFT/RIGHT to pick the desired attenuation.

Press
“OK” to exit the menu
Sample Speed

Use LEFT/RIGHT to toggle between Normal screen update and PEAK to PEAK
mode. (Peak to Peak mode is started by default.)

Press “OK” to exit the menu
Grid Intensity

Use LEFT/RIGHT to adjust the brightness of the graticule lines.

Press “OK” to exit the menu
SigGen Freq (Connect leads to the frequency generator for this option)

This refers to the built in Frequency generator

Use Left/Right to select the Frequency

Press “OK” to exit the menu
SigGen Duty (Connect leads to the frequency generator for this option)

This refers to the built in Frequency generator duty

Use Left/Right to select the Frequency percentage